FIRST: LOCATE WHERE ON THE TAB YOU WANT THE LIGHTS.

SECOND: TIGHTEN THE SET SCREWS. PRETTY EASY SO FAR.
 
THIRD: ZIP TIE THE WIRE ON THE TRIM CYLANDER WITH ENOUGH SLACK FOR THE FULL MOTION OF THE TRIM TAB. WE'RE ALMOST DONE.
 
FOURTH: WITH THE WIRE CLIPS AND SELF DRILLING/THREADING SCREWS RUN THE WIRE TO WHERE YOU WANT THE WIRE TO ENTER THE BOAT. (ABOVE THE WATERLINE!!!)

GOT THAT?  IT'S WORTH REPEATING! (ABOVE THE WATERLINE!!!)

AT THAT LOCATION DRILL A 7/32 HOLE FOR 1 WIRE, OR A 3/8 HOLE FOR 2. POKE THE WIRE THROUGH THE HOLE.

NEXT SQUIRT A LITTLE SILICONE IN THE HOLE, THEN MOUNT THE CLAMSHELL OVER THE WIRES FOR A NICE NEAT FINISH.

NOW YOU'RE FINISHED WITH THE OUTSIDE OF THE BOAT. THAT WAS EASY, WASN'T IT?

NOW COMES THE LAST PART. RUN THE WIRE NEATLY TO THE DASHBOARD, CUT OFF ANY EXTRA AND WIRE TO A FUSED SWITCH OR INSTALL A NEW SWITCH. WE LIKE TO WIRE IT WITH THE COCKPIT LIGHTS.

SWITCH ON AND ENJOY!